PUMP CAPACITY DETERMINATION FOR TWO-PHASE VERTICAL FLUID FLOW
CHAPTER ONE
1.0 Introduction
1.1 Background Of Study
In the production system, Pressure drop has been a major issue in the field. These pressure drops could be experienced as a result of valves and fittings installed, due to friction along pipe sections or in lifting fluid up to a certain level.
As these pressure drops are identified, and the economic flow rate of a reservoir fluid is known, pumps may be employed to reduce the effect of pressure drop and maintain a given fluid flow rate for good economic recovery. These pump applications are usually analysed to determine an optimum Hydraulic pump requirement for a given fluid system and pipe diameter. It can form one of the basic aspect to be considered during well completion in selecting production tubing diameter.
In general, a pump is a device used to transport liquids, gases, and slurries. However,the term pump is usually used to refer to liquid handling equipment. The purpose of the pump is to provide a certain pressure at certain flowrate of a process stream. The pressure requirement is dictated by the process andpiping involved, while the flow rate is controlled by the required capacity in thedownhole units.
At least one out of every 10 barrels of oillifted in the world’s oil and gas operations are produced using an ElectricSubmersible Pump (ESP). Typical installationsproduce liquids in the 2,000 to 20,000 bpd range,making the ESP an effective and economical meansof lifting large volumes of fluids from great depthsunder a variety of well conditions.
There are several types of pumps used for liquid handling. However, these can bedivided into two general forms: positive displacement pumps (including reciprocatingpiston pump and the rotary gear pump), and centrifugal pumps. The selection of thepump type depends on many factor including the flow rate, the pressure, the nature ofthe liquid, power supply, and operating type (continuous or intermittent).
The power requirement for a mechanical system, like pumps and compressors, isgiven by the general mechanical balance equation:
P = -mWs = m 1.1
All terms in this equation take their normal meaning with m being the mass flow rate,and a a coefficient used to take into account the velocity profile inside the pipe (forlaminar a = 0.5, while for turbulent a = 1). The required work (or power) given by Pis the total work that needs to be delivered to the fluid. This work will be drawn froma motor (operated with electricity or engines). The conversion between the motor andpump power is not complete and an efficiency is defined to describe the powerconversion. The efficiency is given by:
The input power can be measured from the source. For example, if the pump is operated with electricity, the input power will be I×V (current times voltage). Theoutlet power can be determined using Equation (1.1).
- Static head (?zterm): the height to which the fluid will be pumped.
- Pressure head ( term): the pressure to which the fluid will be delivered (ina pressurized vessel for example). The pressure units must be converted to lengthunits using relation.
- System or dynamic head (F term): the energy lost due to friction in pipes, valves,fittings, etc.
1.2 Statement Of The Problem
It is important to accurately predict the pressure drop accross a production system. This has been a difficult task in the oil and gas industry as the production system in real life is not homogenous (single phase) as assumed in most theories. The reason for this is that the two-phase flow is complex and difficult to analyze. Ideally, gas moves at a much higher velocity than the liquid. As a result, the down hole flowing pressure of the liquid-gas mixture is greater than the corresponding pressure corrected for down hole temperature and pressure and this could be calculated from the produced gas-liquid ratio.
This pressure drop in a flowing (production) system could be identified using different existing correlations. Some of these correlations are empirical, mechanistic or numerical. Hagedorn and Brown is the most widely used correlation for vertical wells (Schoham, 2006). In planning well completion the tubing diameter that will give less pressure drop hence much liquid production can be selected by the use of multiphase correlation.
It is also very necessary to plan for pumps in tubing size selection should need arise on future production for pumping of the reservoir fluid to optimize production.
1.3 Objective Of The Study
The main objective of this research is to determine the Hydraulic Horse Power Requirement needed to maintain production of reservoir fluid within economic limit.
The above objective can be achieved by using two-phase pressure drop correlations to determine pressure drop in selected production tubing used in the Niger Delta.
1.4 Scope Of The Study
The determination of pressure drop using the selected two-phase correlations using production tubings used most often in the Niger Delta.
CHAPTER TWO
2.0 Literature Review
2.1 Introduction
The review of relevant literature is the main topic of this chapter. A literature review covers theoretical and methodological contributions to a certain issue in addition to the state of knowledge at the time of writing. It provides information about the state of the art in relation to the subject you are writing about. It examines the body of work on the chosen subject. The literature evaluation in this study comprises the …
Procedure for Downloading the PDF (Docx) Material
Pump Capacity Determination for Two-Phase Vertical Fluid Flow can be downloaded by requesting the full set of materials at the project or seminar cost. The document will be sent via Microsoft Word (MS-Word) format via WhatsApp (e-mail) following payment confirmation.
| Seminar Material Cost ₦3,000 | Project Material Cost ₦5,000 |
Request Complete Material
 | Click here to request the Complete Material via WhatsApp including;
|
Disclaimer for Complete Material Utilization
The displayed research work titled "Pump Capacity Determination for Two-Phase Vertical Fluid Flow" is stated as a research guideline towards accomplishing your assigned project / seminar research work. All the research materials on this website are ONLY for research purposes and should be used as a guideline in developing your research work. For no reason should you copy word for word as projectlist.com.ng will not be liable for any who copied the material. By ordering the complete research guideline, it signifies that you've accepted our terms of service.
Frequently Asked Questions (FAQ)
Is the topic “Design and Implementation of Computer Based Scheduling System for a Transport Company” recommended for Computer Science (CS) Project?
Yes it is highly recommended — Scheduling System for Road Transport permits a customer to observe the information about seat reservation, bus schedule and ticket sales as well as bus time of dispatch. The aim of this study is to design and implement a Computer Based Scheduling System for a Transport Company. In achieving this aim, the following specific objectives were laid out to design a workable computer based Scheduling System for a Transport Company that will eliminate completely the above mentioned problems, create a system that can be used to record transportation scheduled records to database, design a system that can be used to accurately compute transportation bills, and design a system that can be utilized to obtain reports of transportation records. The motivation that …
Can the material for “Effect of Health and Safety on Employee’s Productivity” be used as a guide for Industrial Relations and Personnel Management (IRPM) Project?
Yes it can be used — The study was carried out to investigate the Effect of Health and Safety on Employees’ Productivity. In achieving this aim, the following specific objectives were laid out to find out the meaning of the concepts of occupational health and safety, examine the joint effect of occupational health and safety on employee's productivity and determine the relative effects of occupational health and safety on employee's productivity. All data collected from the respondents was analyzed by using descriptive and inferential Statistics. A total of 133 (one hundred and thirty three) respondents were selected for this study to represent the entire population of the study. The Correlation survey design was adopted to guide the study. The Pearson Product Moment Correlation Coefficient was used …
Is the topic “Sea Piracy and Security Challenge of Maritime Operation in Bayelsa State” recommended for Maritime and Transport Project?
Yes it is highly recommended — Sea Piracy without a doubt is one of the most challenging factors that have bedeviled sea transportation along water ways. The study was conducted to investigate the Sea Piracy and Security Challenge of Maritime Operation in Bayelsa State. In achieving this aim, the following specific objectives were laid out to investigate whether sea piracy poses security threat to Maritime business operation and examine whether sea piracy affects fishing business in Bayelsa State Territorial Waters. The research design used in this report is descriptive design, utilizing questionnaire method to obtain information from the respondents for this project. A total of 80 (eighty) respondents were selected for this study to represent the entire population of the study. For null hypotheses were formulated …
Can this topic “Mobile Based Information System for Vegetable Farming” be used for Information System Project?
Yes it can be utilized for research — Vegetables may be described as those plants, which are consumed in relatively small quantities as a side dish with the staple food. The aim of the study is to Design and Implement of a Mobile Based Information System for Vegetable Farming. In achieving this aim, the following specific objectives were laid out to develop a mobile-based application that will enable the farmers search and browse vegetable information without delay, reduce human errors and time spent by farmers filling out forms, freeing resources for more critical farm tasks and ensure proper accountability on the distribution of farming facilities and equipment. The motivation that led to the implementation of the proposed system is as a result of the difficulty encountered in accessing …
Can the material for “The Impact of Supervision of Salesmen on Sales Volume” be used as a guide for Business Administration and Management (BAM) Project?
Yes it can be used — This study aimed at the impact of supervision of salesmen on a sales volume a case study of Eternit Nigeria Plc, Sapele. Supervision is a functional problem in most organizations, because most workers do not want to be controlled or supervised. The problem such as lateness to work, absence from duty, laziness of workers and pride hinder effectiveness of employee. Questionnaire and personal observation was used in the collection of data. Chi-square and simple percentage method was used to analyze data and the formulated hypothesis the results show that; there is significant relationship between supervision of salesmen and sales volume. Therefore for management should make every effort to supervise salesmen because it will make them do their best and increase …
Can this topic “The Issue of the Effectiveness and Regularity of ICT Use Among Business Education Students” be used for Education Project?
Yes it can be utilized for research — Information and Communication Technologies (ICTs) have, over the years, proven to be of great value to the educational sector. Such technologies include the computer, internet, projectors and so on. This study investigates the effectiveness and regularity of ICT use among business education undergraduates. This study was delimited to University of Lagos (UNILAG) and Lagos State University (LASU). The sample population were 200 undergraduates of business education derived from the two universities mentioned above. The Chi-square statistical tool was employed in data analysis. The following recommendations were made: The administration of University of Lagos(UNILAG) AND Lagos State University(LASU) see to it that more ICT tools are provided for the school to accommodate the ever-growing population no students. Since Business education students in the …
Can the material for “A Critical Assessment of Micro Finance Banks and Their Contribution to the Development of Small Scale Enterprises” be used as a guide for Finance Project?
Yes it can be used — This project work is carried out to examine the contribution of micro finance banks to the development of Small and medium scale enterprises in Nigeria. The Brass micro finance bank is used as a case study. Data were collected through a well structured questionnaire and the information elicited from the respondents were analyzed through tabular presentation of data, frequency distribution and percentages. The findings revealed that Microfinance banks have contributed immensely to the development of small scale business in Nigeria and most especially Small Business Ventures. However, it was discovered that the small scale businesses are beset with myriads of problems which can be solved through an improvement in the service of Micro finance banks by the government. …
Can the material for “The Relationship Between Peer Group Pressure and Bullying Among Adolescents in Selected Secondary Schools” be used as a guide for Guidance and Counselling Project?
Yes it can be used — This study examined the relationship between peer group pressure and bullying behavior among adolescents in selected secondary schools in Lagos metropolis. The descriptive survey design was used in this study. The research instrument used for this study was a questionnaire tagged PPBBAQ which was adapted by the researcher. The population of this study covered the students in selected secondary schools in Ejigbo Local Government area of Lagos State where data was collected using simple random sampling. Collected data was analyzed using Pearson moment correlation co-efficient statistical tools, descriptive statistics. Demographic data such as gender, age, and class were used. Findings showed that peer pressure has a relationship with bullying. It was concluded that there is a relationship between bullying and …
Is the topic “Design and Implementation of Commercial Vehicle Registration and Task Management System in a Campus” recommended for Computer Science (CS) Project?
Yes it is highly recommended — Commercial vehicle registration is a job that requires accuracy of data and this exercise is required for every new registration. The emergence of e-data processing system provides answer to the need for tools and alternative ways to improve well-being and activities of individuals. The aim of the study is to design and implement a commercial vehicle registration and task management system for Federal University of Petroleum Resource Effurun (FUPRE) campus. In achieving this aim, the following specific objectives were laid out as follows to design and develop an application software that will provide a better, easier and more efficient method of vehicle registration and equip the field DOT officials with an on-the-spot ease in verifying authenticity of any commercial vehicle …
Can this topic “Analysis of the Role of Insurance Industry in the Promotion of Capital Market Services” be used for Insurance Project?
Yes it can be utilized for research — The topic “Analysis of the roles of insurance industry in the promotion of capital market services” has been adequately researched on. The research identify that the roles of insurance industry in the promotion of capital market had been the major reason for the promoting of insurance industries in the capital market. The research used primary and secondary data collection which was distributed to the respondent and will be interpreted by the respondent. The research question objectives of the study, the research hypothesis were all validated and if at the end it was discovered that the promotion of capital market in the role of insurance industry has been the main stay of any insurance company. …