Project Topics | Seminar Topics | Related Topics
Measurement and Evaluation of the Performance Properties of Selected Locally Produced Lubricants (Engine Oil)

MEASUREMENT AND EVALUATION OF THE PERFORMANCE PROPERTIES OF SELECTED LOCALLY PRODUCED LUBRICANTS (ENGINE OIL)


ABSTRACT

The performance of the oils selected in this work was tested for considering Viscosity, Viscosity Index, Density, Flash Point, Pour Point, and Carbon Residue. The most important of all the properties which makes the oil protect against wear is viscosity that helps to reduce friction between moving parts in the engine. The Viscosities of the oils; Oando SAE 20W50, Total SAE 20W50, Mobil 1 SAE 0W40, Total SAE 40, and AZ SAE 20W50 at 24.8°C (room temperature) and 100°C (maximum test temperature) are 290 cSt and 18 cSt, 290.5 cSt and 20 cSt, 286.4 cSt and 21.20 cSt, 295.2 cSt and 15.60 cSt, 296.8 cSt and 19.60 cSt respectively. This implies that the Mobil 1 is most preferred as it has the least change in viscosity with respect to change in temperature and Total SAE40, a monograde oil as the least preferred as it has highest change in viscosity with respect to change in temperature when high temperature is expected in the service environment. The pour points of the oils are -240C, -22 0C, -280C, -150C, and -220C respectively.

Based on this, all the oils are suitable for use in internal combustion engine in Nigeria and Africa. However, in an environment where very low temperature is expected during winter, the Mobil 1 (synthetic Oil) is most preferred and the monograde Oil is not suitable as the flowability may not be good enough at engine start up. The flash point of the Oils is 175 0C, 160 0C, 160 0C, 102 0C, and 170 0C respectively. These Oils are suitable for use in internal combustion engine as all the flash points are above the expected temperatures (0C) during a normal working condition. The carbon residue found in the Oils was 0.95 %, 0.90 %, 0.60 %, 1.00 %, and 0.95 % respectively. The Synthetic Oil has the lowest carbon residue and the monagrade Oil has the highest carbon residue, and so the synthetic Oil is most preferred based on carbon residue result since high amount of carbon residue is a disadvantage. In all the results of laboratory test, all the Oils were seen to be suitable in internal combustion engine with the most preferred Oil as the synthetic followed by the multigrade and the least performing oil is the monograde.

To carry out Pressure Mapping Experiment in this work, a pressure mapping equipment was developed. An Internal Combustion Engine, Thermocouple, Tachometer and Pressure Tube were obtained from the market and integrate together to function as desired based on theoretical background of pressure mapping. The pressure mapping experiment is a fast method of measuring the performance of the lubricating Oil by mapping the pressure of the Oils in an internal combustion engine. This Oil pressure mapping is recommended for the evaluation of the performance properties of the Oils in our local market.


CHAPTER ONE

1.0 Introduction

1.1 Preamble

From time immemorial, liquids, including water, have been used as lubricants to reduce friction and wear and remove heat between two surfaces in contact. At present, lubricating oil also called lube oil is the most commonly used lubricant because it has found a wide range of application in the field of engineering.

A lubricant, sometimes called lube, is a substance (often a liquid) which is introduced between two surfaces in contact moving relative to each order to keep them separate under all loads, temperatures and speed thus minimizing friction and wear. The substance may act as cooling fluid removing heat from the system and also protect surfaces from the attack of aggressive products formed during the operation. Lubricants may also perform the function of dissolving and transporting foreign particles.

Majorly, there are solid and liquid lubricants. Air and other gas based lubricants are there, but for the purpose of this research work, consideration is limited to liquid lubricants. Examples of liquid lubricants are: mineral oils, vegetable oils and synthetic oils.

The most common liquid lubricants are the mineral oils. This is because of the supply of crude oil. The term mineral oil is used here to mean lubricating base oil derived from crude oil that is refined from naturally occurring petroleum. Since they are commonly used, important information about their properties is now available.


CHAPTER TWO

2.0 Literature Review

2.1 Introduction

The review of relevant literature is the main topic of this chapter. A literature review covers theoretical and methodological contributions to a certain issue in addition to the state of knowledge at the time of writing. It provides information about the state of the art in relation to the subject you are writing about. It examines the body of work on the chosen subject. The literature evaluation in this study comprises the …


Procedure for Downloading the PDF (Docx) Material


Measurement and Evaluation of the Performance Properties of Selected Locally Produced Lubricants (Engine Oil) can be downloaded by requesting the full set of materials at the project or seminar cost. The document will be sent via Microsoft Word (MS-Word) format via WhatsApp (e-mail) following payment confirmation.


Seminar Material Cost
₦3,000
Project Material Cost
₦5,000


Request Complete Material

Complete Material Chapters of Measurement and Evaluation of the Performance Properties of Selected Locally Produced Lubricants Engine OilClick here to request the Complete Material via WhatsApp including;
  • Preliminary Pages,
  • Chapter 1-5,
  • References and Appendix.



Disclaimer for Complete Material Utilization

The displayed research work titled "Measurement and Evaluation of the Performance Properties of Selected Locally Produced Lubricants (Engine Oil)" is stated as a research guideline towards accomplishing your assigned project / seminar research work. All the research materials on this website are ONLY for research purposes and should be used as a guideline in developing your research work. For no reason should you copy word for word as projectlist.com.ng will not be liable for any who copied the material. By ordering the complete research guideline, it signifies that you've accepted our terms of service.


Frequently Asked Questions (FAQ)


Can the material for “The Impact of Electoral Malpractices on Democratic Process in Nigeria” be used as a guide for Political Science Project?

Yes it can be used — By its very nature, electoral malpractice is a subversion of the constitution and the democratic form of government instituted by the Constitution of any given country. Election is one of the most important pillars of democracy. Indeed, it is a necessary condition for democracy because it provides the medium for the expression of the core principles and purposes of democracy such as the sovereignty of the citizens; freedom, choice and accountability of political leaders. In order to serve these purposes of democracy, elections must be free and fair void of manipulation, violence and fraud as well as impactiality of election management authority and effective participation by the electorate at all stages of the electoral process. This research work analyzed the interface …


Can the material for “The Effect of Information Communication Technology (ICT) on Students’ Academic Performance on Mathematics” be used as a guide for Mathematics Education Project?

Yes it can be used — The study attempted to examine the effect of information communication technology (ICT) on students’ academic performance in Mathematics in selected secondary schools in Kosofe Local Government Area of Lagos State. In this study, relevant and extensive literature was reviewed under subheadings. The survey research design was used to assess responses of the selected respondents, with the application of the questionnaire and the sampling technique. A total of 200 (two hundred) respondents were selected and used for this study, which represented the bulk of the population. Five (5) null hypotheses were formulated and tested in this study, using the Pearson product moment correlation and the independent t-test statistical tool at 0.05 level of significance. Based on the data analyses, it was concluded that …


Can the material for “Design and Implementation of a Web Based Vehicle Repair and Maintenance Information System” be used as a guide for Computer Science (CS) Project?

Yes it can be used — Vehicle Repair and Maintenance Information System is a guide with an interactive tool which provides drivers with comprehensive and convenient information which are meant not only to help them whenever they meet with an unforeseen incident on the road or at any point in time. The aim of the study is to design and implement a Web based Vehicle Repair and Maintenance Information System. In achieving this aim, the following specific objectives were laid out as follows to develop an application software that will develop appropriate representation architecture to the proposed car failure and malfunction diagnosis assistance system and also help vehicle repairers diagnose serious faults and repair vehicles at a faster rate through the pre-diagnosis and advice a web-based …


Can the material for “Effectiveness of Exclusive Breastfeeding in the Development of Under 5 Children” be used as a guide for Nursing (Science) Project?

Yes it can be used — The purpose of this study was to examine the effectiveness of exclusive breastfeeding in the development of children under-five in Benue State, Nigeria. To achieve this purpose, 10 hospitals were randomly selected using multi-stage sampling technique (simple random, stratified, and purposive sampling techniques). The data was collected using close-ended questionnaire. 500 questionnaires were distributed to nursing mothers who visited antenatal clinics in the randomly selected hospitals, from which 455 were duly completed and returned. Frequencies of percentages and cross tabulation statistics were used to answer research questions. Associations between demographic determinants and breastfeeding practices were analyzed using Chi-square statistics at alpha level of 0.05 to test the formulated hypotheses. The findings of the study, indicated high (99.8%) prevalence of breastfeeding among …


Can the material for “Reward and Workers’ Performance in Banking Industry” be used as a guide for Business Administration and Management (BAM) Project?

Yes it can be used — The study examined the impact of reward on employees’ performance at First Bank Plc. Chapter one examined four research questions and four research hypotheses which were formulated in the null forms. The significance of the study was also examined which its scope was limited to the First Bank Nigeria Plc located in Lagos State. Relevant literature from various authorities were reviewed under the following sub-headings: Theoretical framework, importance of reward and workers’ productivity; motivation among Nigerian employees, the banking hospitality, an empirical studies of related to the use of tangible and intangible rewards in employees motion, concept and types of motivation, the process of reward and so on. The methodology which further dwelt on the following: research technique, instrumentation, procedure …


Can the material for “Firm Age and Profitability; Evidence From Nigeria” be used as a guide for Economics Project?

Yes it can be used — This study sought to investigate firm Age and Profitability: Evidence from Nigeria. The main objective of this study is to determine if firm age affect the profitability of non-financial companies in Nigeria and also to know if older firms out performs younger firms. Age can have adverse effects on performance also because of the organizational rigidities and inertia it brings about and because it impairs the ability affirm to perceive valuable signals. Descriptive statistic and correlation analysis which tests for normality and association among the data in the variables in the model specified and a cross sectional analysis was carried out by way of panel data regression technique. The study concluded that young firms are better but the higher the age, …


Can the material for “Design and Implementation of a Web NITEL Telephone Billing System” be used as a guide for Computer Science (CS) Project?

Yes it can be used — NITEL Telephone billing system is a process of gathering consumption data, calculating billing and charging information, availing customer bills, processing the customer payments as well as managing collection of debts. The aim of the study is to design and implement a web based NITEL Telephone Billing System for effectiveness and ease of the problems facing the manual system. In achieving this aim, the following specific objectives were laid out to design and develop an application software that will identify the problems that are encountered in the manual telephone System, ensure accuracy in the daily telephone billing operations or activities and Detect sources of these errors and arrive at system that takes care of anomalies and give customers the best possible …


Can the material for “A Comparative Study of the African and the European Regional Systems for Protection of Human Rights: Lessons for Africa” be used as a guide for Political Science Project?

Yes it can be used — African and European human rights systems are usually described as young-ineffective and old-effective respectively. Though plenty of scholarly works exists about the two systems, there is lack of comparative studies which tries to elicit similarities and differences between the two systems. Other than providing a descriptive account of the African system and categorizing it as young and ineffective, the existing literatures particularly failed to point-out lessons which can be drawn from experiences of the categorically effective European system. Therefore, by employing the Most Similar Systems Design of the comparative approach under the general qualitative framework, utilizing descriptive and exploratory techniques and based on documentary sources of information, this study examined the similarities and differences between the European and African human …


Can the material for “Design and Implementation of a Computerized e-Learning and e-Education Web Portal” be used as a guide for Computer Science (CS) Project?

Yes it can be used — E-education is the process of learning online. Whether you’re a high school student or a Tertiary institution student, a person looking to expand technical skills or a retiree who simply wants to learn more, Internet learning provides a boundary-free way to broaden your horizons. The aim of the study is to develop a computerized e-Learning and e-Education Web Portal using Computer Science Department in NOUN University as a case study. In achieving this aim, the following specific objectives were laid out as follows to design an application that will, provide alternative way of attaining education, facilitate the development of information technology, enhance examination and certification of students thereby improving the standard of education, reveal the use and technology of wireless …


Can the material for “Marital Conflict and Church Roles to Maintaining Stability” be used as a guide for Religious Studies Project?

Yes it can be used — Marital conflict is the state of tension or stress between marital partners as the couple try to carry out their marital roles. Marital conflict can also be described as a struggle, clash, strife, disagreement or quarrel between husband and wife, and sometimes with other members of the household, over opposing needs, ideas, beliefs, values or goals Cummings. The study was carried out to scrutinize the Marital Conflict and Church Roles to Maintaining Stability. In achieving this aim, the following specific objectives were laid out to determine the causes of conflict and conflict resolution, impact of educational attainment level on marital stability and determine the relationship between educational attainment level and Marital Conflict of married persons in Imo State. The motivation …



Chat with us on WhatsApp