Project Topics | Seminar Topics | Related Topics
Design and Implementation of a Computer Based Child Care Information System (A Case Study of Inicef Enugu)

DESIGN AND IMPLEMENTATION OF A COMPUTER BASED CHILD CARE INFORMATION SYSTEM


CHAPTER ONE

1.1 Introduction

… This chapter will address the background information that motivated this study, the challenges that prompted it, its aim, and its objectives as a preface to subsequent sections of the study. Additional factors include the study's significance, scope, limitations, research questions and hypotheses, and the definition of technical terms.


CHAPTER TWO

2.0 Literature Review

2.1 Introduction

The review of relevant literature is the main topic of this chapter. A literature review covers theoretical and methodological contributions to a certain issue in addition to the state of knowledge at the time of writing. It provides information about the state of the art in relation to the subject you are writing about. It examines the body of work on the chosen subject. The literature evaluation in this study comprises the …


Procedure for Downloading the PDF (Docx) Material


Design and Implementation of a Computer Based Child Care Information System (A Case Study of Inicef Enugu) can be downloaded by requesting the full set of materials at the project or seminar cost. The document will be sent via Microsoft Word (MS-Word) format via WhatsApp (e-mail) following payment confirmation.


Seminar Material Cost
₦3,000
Project Material Cost
₦5,000


Request Complete Material

Complete Material Chapters of Design and Implementation of a Computer Based Child Care Information System A Case Study of Inicef EnuguClick here to request the Complete Material via WhatsApp including;
  • Preliminary Pages,
  • Chapter 1-5,
  • References and Appendix.



TABLE OF CONTENTS

PRELIMINARY PAGES


CHAPTER ONE

INTRODUCTION

  • 1.1 Introduction
  • 1.2 Background of Study
  • 1.3 Statement of the Problem
  • 1.4 Aim and Objective of the Study
  • 1.5 Significance of Study
  • 1.6 Scope of Study
  • 1.7 Limitations of the Study
  • 1.8 Definition of Terms

CHAPTER TWO

LITERATURE REVIEW

  • 2.1 Introduction

CHAPTER THREE

SYSTEM ANALYSIS AND DESIGN

  • 3.1 Methodology Adopted
  • 3.1.1 Problem Identification Using SSADM
  • 3.2 Analysis of the Existing System
  • 3.2.1 Dataflow of the Existing System
  • 3.2.2 Disadvantages Of The Existing System
  • 3.2.3 Weakness of the existing System
  • 3.3 Feasibility Study
  • 3.3.1 Economic Feasibility
  • 3.3.2 Technical Feasibility
  • 3.3.3 Operational Feasibility
  • 3.4 Analysis of the Proposed System
  • 3.4.1 Data Flow Diagram of the Proposed System
  • 3.4.2 Advantages of the Proposed System
  • 3.4.3 Justification of the Proposed System
  • 3.5 Functional Requirements
  • 3.5.1 Use Case Diagram Of The Admin / User Privileges
  • 3.6 Data Requirements
  • 3.7 High Level Model of the Proposed System

CHAPTER FOUR

SYSTEM DESIGN AND IMPLEMENTATION

  • 4.1 Objectives of the Design
  • 4.2 Cohesion and Decomposition High level Model
  • 4.3 Control Center / Overall Dataflow Diagram
  • 4.3.1 Proposed System Operation Flowchart
  • 4.4 System Specification and Design
  • 4.4.1 Input and Output Specification
  • 4.4.2 Database Specification and Design
  • 4.4.3 Data Dictionary
  • 4.5 Choice and Justification of Programming Language
  • 4.6 Program Documentation
  • 4.7 Implementation Techniques
  • 4.7.1 System Testing
  • 4.8 Programming Module Specification
  • 4.8.1 Installation
  • 4.9 Computer Hardware Minimum Requirement
  • 4.10 Software Requirement
  • 4.11 Personnel / User Training
  • 4.12 File Maintenance Module

CHAPTER FIVE

SUMMARY, CONCLUSION AND RECOMMENDATION

  • 5.1 Introduction
  • 5.2 Summary
  • 5.3 Conclusion
  • 5.4 Recommendation

REFERENCES

APPENDIX A - “SOURCE CODE”

APPENDIX B - “OBJECT PROGRAM”


Disclaimer for Complete Material Utilization

The displayed research work titled "Design and Implementation of a Computer Based Child Care Information System" is stated as a research guideline towards accomplishing your assigned project / seminar research work. All the research materials on this website are ONLY for research purposes and should be used as a guideline in developing your research work. For no reason should you copy word for word as projectlist.com.ng will not be liable for any who copied the material. By ordering the complete research guideline, it signifies that you've accepted our terms of service.


Frequently Asked Questions (FAQ)


Can this topic “Recalibration of 250ml Volumeter Flask” be used for Science Laboratory Technology (SLT) Project?

Yes it can be utilized for research — Recalibration of 250ml volumetric flask from time to time is very vital for determination of its accuracy and precision compared with its original manufacturers calibration. It gives a sound understanding of modern measurement methods and knowledge of equipment used. Glass is known to play an important role in the modern technology as it is used in the production of laboratory apparatus, e.g. volumetric flask, measuring cylinder etc. From this project work, it was shown in chapter three and four that recalibration is all about quantitative measurement and the process of checking a measuring system of equipment readings against a higher reference standard. The results in chapter four were checked against the tolerance of class a volumetric flask in table one. The …


Can the material for “Design and Fabrication of a Laboratory Centrifuge” be used as a guide for Mechanical Engineering Project?

Yes it can be used — A Laboratory Centrifuge is a piece of equipment generally driven by an electric motor and some older ones usually spun with hand, that puts an object in a rotation around a fixed axis, applying a force perpendicular to the axis. The study was conducted to design and fabricate a Laboratory Centrifuge using local materials. It spun liquid samples at a high speeds and thus creates a strong centripetal force causing the denser materials to travel towards the bottom of the centrifuge tube more rapidly that they would under the force of normal gravity. The present high cost of imported centrifuges necessitates the design and construction of A Laboratory Centrifuge using local raw materials. The use of steel for the construction of …


Can the material for “An Assessment of the Management of Garbage Collection and Waste Disposal” be used as a guide for Environmental Science Project?

Yes it can be used — Poor waste management has been a major problem to human existence and it affects both rural and urban areas. Various methods of waste disposal exist and this study assessed the waste man- agement practices among residents of Owerri State, Imo state, Nigeria. It was a descriptive cross sectional study in which a total of 282 residents of Owerri State were selected by multi- stage sampling technique and studied using self and interviewer administered questionnaires. The results showed that 90% of respondents were aware of waste management while 97.5% had posi- tive attitude towards it. The major types of waste generated from households were food residues (97.1%) and vegetable products (95.4%). Also poor waste management practices among residents include open dumping, …


Can the material for “Utilization of ICT in Education of Student with Visual Impairment in Two Tertiary Institutions” be used as a guide for Computer Science Education Project?

Yes it can be used — The study investigates the Utilization of Information Communication Technology in Education of Student with Visual Impairment in Nasarawa State University and Federal University Lafia. In achieving this aim, the following specific objectives were laid out to examine the ICT facilities adopted in the teaching and learning at tertiary Institution level, find out if ICT provides access to teaching aids for teaching and learning, find out if ICT provides proper management of large number of students in teaching and learning, investigate if ICT promotes independent studies among students in teaching learning, and find out if ICT increases students performances in teaching and learning in Nasarawa State University and Federal University Lafia. The research design used in this report is descriptive design, …


Can the material for “Critical Evaluation of Travel Time in Owo” be used as a guide for Civil Engineering Project?

Yes it can be used — Travel time and travel time reliability are important performance measures for assessing traffic condition and extent of congestion on a roadway. The aim of the study is to analyze the Travel Time in Owo using Oke Ogun Road as a case study. In achieving this aim, the following specific objectives were laid out to formulate a methodology to obtain travel time data using Bluetooth technology on a freeway segment and collect travel time data,and observe daily and inter-daily variations as well as those due to poor weather conditions and estimate econometric models to predict travel time and variability. The research design used in this report is descriptive design, utilizing questionnaire method to obtain information from the respondents for this project. …


Can the material for “Need for Training and Development of Suppliers Personnel in the Public Sector” be used as a guide for Purchasing and Supply (PS) Project?

Yes it can be used — The study was carried out to examine the need for training and development of supplies personnel in a public sector. The researcher has chosen Ministry of Agriculture and Natural Resources, Imo State as a case study whose result and findings will be used to generalize with the need for training and development of supplies personnel in other public sector or organizations. The problem found in this sector is that government are yet to be conceived of the need for efficient and organized department to be run by properly trained unqualified and unskilled personnel who cannot cope with the present day complexity of administration and management thereby endangering the smooth operation of the sector. It is the purpose of this study to …


Can the material for “Electronic Logbook for Students Industrial Work Experience Scheme (S.I.W.E.S)” be used as a guide for Computer Science Education Project?

Yes it can be used — The Students Industrial Work Experience Scheme (S.I.W.E.S) is an industrial training program for Nigerian university undergraduate students and other higher institutions. The aim of the study is to design and implement Electronic Logbooks For Students Industrial Work Experience Scheme (SIWES). In achieving this aim, the following specific objectives were laid out as follows to develop an application software that will Provide opportunities to apply their knowledge to actual practice thus making the college work easier and Enable students to practice theory at school, and to provide access to the non-school production equipment. The motivation that led to the implementation of the proposed system is that the existing system there is unnecessary delay in the payment of students and supervisor allowance, …


Can the material for “Teacher Academic Qualification as a Predictor of Academic Performance in Junior Secondary School” be used as a guide for Education Project?

Yes it can be used — This research work investigated Teacher Academic Qualification as a predictor of Academic Performance in Junior Secondary Schools. The descriptive research design was used in carrying out the study. Fifty respondents were selected using the simple random sampling technique. Data collected was analysed using the simple percentage. Result from the study reveals that the teachers subject mastery aids good teaching enhancing pupils academic performance. It also shows that the more learned the teacher is, the better the output. The study recommends that periodic in-service training/workshop be organised for teachers to enhance productivity. …


Can the material for “The Implications of Ownership Structure of Insurance Companies on Policy Holders Patronage” be used as a guide for Insurance Project?

Yes it can be used — This study is titled the implications of ownership structure of insurance companies on policy holders patronage. I looked into the problem that often associates with ownership structure of insurance companies in Nigeria like lack of fund for expansion in order to carryout its day to day activities, bad records of some past insurance companies in Nigeria, the background of the company and lack of governments total supervision over the companies. I equally looked into the objectives of the study which include identifying the effect of each ownership structure and its implication on the policyholder and also identifying the possible solution in tackling the effects of policyholder’s patronage to private indigenous companies. Through the literature review, it should be noticed that work …


Can the material for “The Impact of Proper Underwriting in Promoting Insurance Image in Nigeria” be used as a guide for Insurance Project?

Yes it can be used — Insurance companies are legal entities that cover the insured against certain unexpected occurrence of an event in exchange for payment of a predetermined amount of money called premium. In underwriting insured risks insurance companies do accepts risks that have different risk profile but the acceptance of those risks are under different conditions which they face a lot of challenges in carrying out these activities because of low modern technology and facilities, lack of professionals in underwriting department which brought to foe low confidence on the insured. This study therefore is exploratory study to determine the impact of proper underwriting in promoting insurance image in Nigeria. The population of the study comprises both underwriters and insured of Niger insurance plc Enugu. Both …



Chat with us on WhatsApp